Chapter 11 – Troubleshooting
TB66J – 0083740 71
Fuel Line Air Bleeding – Kubota V2403-M-T
If the engine will not start because of air in the fuel line,
use one of the following methods to remove the air to
restart the engine.
Open Bleeder Valve and Crank Engine
Slightly open the bleeder valve (refer to Figure 11.1)
and crank the engine for a few seconds to let the air
out. Close the valve and start the engine.
Figure 11.1 – Kubota V2403-M-T
Fill the Fuel Filter
Remove the fuel lter. Fill the lter with fuel of the cor-
rect grade and replace it. Crank the engine for a few
seconds to start the engine.
Operate Bleeder Pump
Slightly open the bleeder valve and operate the bleeder
pump up and down until the air is out of the line. This
make take several minutes of operating the pump before
the air is removed from the line. Close the valve and
start the engine.
Bleeder Valve
Fuel Filter
Bleeder Pump
Fuel Line
To Next Page
Loading...
