Step 5 | Switch your Pico on and start monitoring
Battery Indicator Light
Breathing Movement Indicator Light
Alarm Indicator Light
Bluetooth and Notification Light
Speaker Holes
Power Button/Mode Button
Clip Lever
-
-
-
-
-
-
-
1
2
3
4
5
6
7
Non-contact Sensor
Charging Pins
Temperature Sensor
Clip
-
-
-
-
8
9
10
11
Charging Cable
Power Indicator Light
Charging Cradle
-
-
-
12
13
14
Important Precautions
Only use the Pico when your baby is sleeping in his/her own bed/cot/crib. As the Pico monitors movement, movement from external sources such
as being pushed in a pram or traveling in a vehicle may be picked up by the sensors. The Pico should not be relied on where external sources of
movement are present. While feeding or changing your baby's diaper, it is recommended that you pause the Pico to avoid false alarms. This product
is not suitable for co-sleeping or bed-sharing. The Snuza Pico is a baby care-aid, not a medical device. It is not intended for the diagnosis, prevention
or monitoring of a disease, injury or handicap.
For additional product information, please consult the instruction manual at https://www.snuza.com/snuza-manuals/
Switch the Pico on by briefly pressing the power button. All indicator lights will flash and a start-up tone will be heard. Alternatively, switch
the Pico on by pressing the power button in the app. The start-up tone will be silent if controlled via the app.
• Immediately after the start-up sequence, the battery light will flash green to indicate the battery state of charge.
• If not already connected to your app, press the "Connect" button in the app overview screen to initiate the connection to your phone.
To Next Page
Loading...
Need help?
General
