5
5
Make sure the scanner is not connected to a host computer or device before scanning a
command barcode.
Factory Reset
Configures the scanner to factory defaults. The scanner powers off after scanning this barcode.
Pairing Reset
If the scanner is paired with a device, unpair it before trying to connect to a different device.
Step 1: Scan barcode (for serial number that begins 1931 and above only).
Or follow steps to manually reset scanner:
A. Power on the scanner.
B. Press and hold down the scan button.
C. Press and hold down the power button.
D. After you hear 3 beeps, release both buttons.
The scanner will unpair and automatically power off.
Step 2: Remove or forget the scanner from the Bluetooth list on the host device.
The scanner is now discoverable.
Both steps above must be done to complete the unpairing.
RESETS
To Next Page
Loading...
