SoClean 2 User Guide

8
Getting Started
1. Pre-washing your PAP Equipment
Use two capfuls of the included pre-wash
with a gallon of water to wash your PAP
equipment (mask, hose, and reservoir), then
rinse thoroughly with clean water.
Note: The SoClean 2 uses no fluids in its
operation. The pre-wash is supplied for
hand washing your PAP equipment only.
DO NOT immerse your SoClean in water.
2. Installing the Injection Fitting
The injection fitting connects the SoClean
to your PAP machine. Once installed, you
do not need to disconnect the injection
fitting to use your PAP. You may leave the
SoClean connected to your PAP. If you
need instructions for connecting to your
specific PAP model, please visit our website
www.SoClean.com.
With humidifier: Disconnect your PAP
hose from your PAP machine. Position
the injection fitting onto the port of your
humidifier, allowing the smaller tubing to
enter into the reservoir. The end of the
tubing should rest on or near the bottom
of the reservoir, over the heat plate. If
necessary, carefully trim the injection tubing
in increments until it is the correct length.

SoClean 2 Specifications

General

Brand	SoClean
Model	2
Category	Accessories
Language	English