To Next PageTo Next Page
Need help?Do you have a question about the SoClean SC1200 and is the answer not in the manual?
SoClean is not currently covered by health insurance.
HSA/FSA accounts can be used for purchase; product list number is #9274.
Works with most CPAP/BiPAP machines; a free adapter is included for compatibility.
Compatible with most CPAP masks; some full-size masks may not fit.
Filter and check valve need replacement every six months; machine indicates when needed.
SoClean 2 is for home use with automatic features; SoClean 2 Go is smaller for travel with battery power.
Can be kept attached permanently; some heated hose setups may require water chamber disconnection.
Preferably level with CPAP for easier flow; can be placed on a shelf below if check valve is monitored.
Tube needs submersion if reservoir has water; can run without water in reservoir.
Minimal effect on CPAP air pressure; heated hose adapter may be needed for BI-PAP/A-PAP.
Comes with a two-year warranty; tested to run over 5 years without issues.
Only CPAP masks with headgear should be placed in the SoClean chamber.
Pre-wash is fragrance-free dish soap; use to wash CPAP reservoir, hose, and mask.
Works with heated humidifiers, which are standard on most CPAP machines.
Can be used with or without a humidifier to sanitize hose, mask, and headgear.
Distilled water is recommended due to sediment and minerals in tap water.
Works with heated hoses, but requires a heated hose adapter (included).
Recommended run time is 5-10 minutes daily, preset to 7 minutes.
Chamber dimensions are 5"x5" opening and 7" deep; any mask fitting these dimensions will work.
SoClean sanitizes; manual washing is still recommended every 5-6 weeks for oils/dust.
Inhibits facial oil build-up but does not remove it; wipe mask periodically.
It is better to run the SoClean when your CPAP mask is completely dry.
Refilling reservoir before or after use does not make a significant difference.
Personal decision; SoClean sanitizes the water in the humidifier each run.
Likely oily residue, not mask deterioration; mask is fine after cleaning.
Activated oxygen (O3) is a three-atom oxygen molecule with powerful oxidizing properties.
Activated oxygen is a natural disinfectant used in various applications.
Occurs in nature and is used commercially; SoClean encloses it and converts it back to oxygen.
The terms activated oxygen and ozone are interchangeable.
Uses enough ozone for sanitation; concentration decreases to 0 ppm by the time the chamber is opened.
Compatible with acrylics, polycarbonate, and silicone; materials withstand ozone cleaning.
Produces activated oxygen from regular air; no additional supplies are needed.
Produces activated oxygen from air and converts it back to regular oxygen via a filter.
Ensure lid is secure; escaped ozone molecules are dispersed and not hazardous.
A heated hose has an electrical connection for humidification comfort and to prevent rainout.
Adapters are needed for some CPAP brands/models for setup and heated hose functionality.
Caused by missing side slot plug or CPAP hose diameter being too thin.
Indicates filter/check valve replacement is due; reset procedure involves button combination.
Used for first use or new equipment to wash mask, hose, and reservoir.
Byproduct of oxidation; odor decreases with time or by adjusting cleaning time.
Indicates that the batteries need to be replaced.
Usually caused by built-up facial oils, not plastic yellowing.
SoClean is not currently covered by health insurance.
HSA/FSA accounts can be used for purchase; product list number is #9274.
Works with most CPAP/BiPAP machines; a free adapter is included for compatibility.
Compatible with most CPAP masks; some full-size masks may not fit.
Filter and check valve need replacement every six months; machine indicates when needed.
SoClean 2 is for home use with automatic features; SoClean 2 Go is smaller for travel with battery power.
Can be kept attached permanently; some heated hose setups may require water chamber disconnection.
Preferably level with CPAP for easier flow; can be placed on a shelf below if check valve is monitored.
Tube needs submersion if reservoir has water; can run without water in reservoir.
Minimal effect on CPAP air pressure; heated hose adapter may be needed for BI-PAP/A-PAP.
Comes with a two-year warranty; tested to run over 5 years without issues.
Only CPAP masks with headgear should be placed in the SoClean chamber.
Pre-wash is fragrance-free dish soap; use to wash CPAP reservoir, hose, and mask.
Works with heated humidifiers, which are standard on most CPAP machines.
Can be used with or without a humidifier to sanitize hose, mask, and headgear.
Distilled water is recommended due to sediment and minerals in tap water.
Works with heated hoses, but requires a heated hose adapter (included).
Recommended run time is 5-10 minutes daily, preset to 7 minutes.
Chamber dimensions are 5"x5" opening and 7" deep; any mask fitting these dimensions will work.
SoClean sanitizes; manual washing is still recommended every 5-6 weeks for oils/dust.
Inhibits facial oil build-up but does not remove it; wipe mask periodically.
It is better to run the SoClean when your CPAP mask is completely dry.
Refilling reservoir before or after use does not make a significant difference.
Personal decision; SoClean sanitizes the water in the humidifier each run.
Likely oily residue, not mask deterioration; mask is fine after cleaning.
Activated oxygen (O3) is a three-atom oxygen molecule with powerful oxidizing properties.
Activated oxygen is a natural disinfectant used in various applications.
Occurs in nature and is used commercially; SoClean encloses it and converts it back to oxygen.
The terms activated oxygen and ozone are interchangeable.
Uses enough ozone for sanitation; concentration decreases to 0 ppm by the time the chamber is opened.
Compatible with acrylics, polycarbonate, and silicone; materials withstand ozone cleaning.
Produces activated oxygen from regular air; no additional supplies are needed.
Produces activated oxygen from air and converts it back to regular oxygen via a filter.
Ensure lid is secure; escaped ozone molecules are dispersed and not hazardous.
A heated hose has an electrical connection for humidification comfort and to prevent rainout.
Adapters are needed for some CPAP brands/models for setup and heated hose functionality.
Caused by missing side slot plug or CPAP hose diameter being too thin.
Indicates filter/check valve replacement is due; reset procedure involves button combination.
Used for first use or new equipment to wash mask, hose, and reservoir.
Byproduct of oxidation; odor decreases with time or by adjusting cleaning time.
Indicates that the batteries need to be replaced.
Usually caused by built-up facial oils, not plastic yellowing.
The SoClean device is a CPAP cleaner and sanitizer designed to maintain the hygiene of CPAP equipment. Its primary function is to sanitize CPAP masks, hoses, and reservoirs using activated oxygen (ozone). This process aims to kill germs, bacteria, and other pathogens that may accumulate on the equipment.
The SoClean operates by converting regular oxygen from the air into activated oxygen (O3) for the sanitizing process. This activated oxygen is then circulated through the CPAP equipment within a secure chamber. After the sanitization cycle, a filter in the chamber converts the activated oxygen back into regular oxygen (O2) before it exits, ensuring that no harmful ozone is released into the room. The device is designed to keep the activated oxygen enclosed within the CPAP equipment and the secure chamber during operation.
The sanitization process is effective in eliminating various microorganisms, contributing to a cleaner and healthier CPAP experience. While it effectively sanitizes, it's important to note that the SoClean does not remove facial oils, dust, or other foreign materials from the mask. For these, periodic hand washing with a pre-wash solution is recommended.
The SoClean is compatible with most CPAP and BiPAP machines. It comes with a free adapter to ensure compatibility with various machine models, including those with heated hoses. For heated hoses, a specific heated hose adapter is required to maintain their functionality.
The SoClean is designed for ease of use. Once set up, it can be left permanently attached to the CPAP machine, eliminating the need to disconnect and reconnect equipment daily. This continuous attachment simplifies the cleaning routine. The device is recommended to run for 5-10 minutes each day, with a preset time of 7 minutes. If the CPAP machine is run dry (without water in the humidifier), the cleaning time can be reduced to 3-5 minutes. If users experience an odor of oxidation, the cleaning time can be increased to 12 minutes for a few weeks to help dissipate the smell.
The SoClean can be used with or without a humidifier. If a humidifier is not used, the device will sanitize the CPAP hose, mask, and headgear. When a humidifier is in use, the SoClean also sanitizes the water in the humidifier reservoir. While it's a personal decision whether to replace the water in the CPAP reservoir regularly or just add water as needed, the SoClean ensures that the water is sanitized during each cycle.
For optimal performance, it is preferable to position the SoClean cleaner and sanitizer level with the CPAP machine to facilitate easier flow. However, it can be placed on a shelf below the CPAP unit, provided that the check valve assembly is periodically inspected for water in the clear tube, which could harm the SoClean unit. If water is observed, the check valve assembly should be replaced.
The device is designed to accommodate most CPAP masks. The chamber has a 5" x 5" opening and is 7" deep, fitting any mask within these dimensions. However, some full-size masks may not fit.
The SoClean can be used with an HSA or FSA account, as it is an eligible product with list number #9274.
Regular maintenance of the SoClean device involves replacing the filter and check valve every six months of normal use, or depending on run times. These components are sold together in a kit, and the machine is programmed to notify the user when they are needed. When the device displays flashing lights and a "time to order" message, it indicates that these parts need to be changed. After replacement, the message can be cleared and reset by holding down the hourglass and manual buttons together until a smiley face icon appears on the display screen.
A neutralizing pre-wash is provided with the SoClean. This fragrance-free, hypoallergenic cleaning solution is intended for use prior to the first use of the SoClean or when introducing new equipment to the CPAP cleaning system. Its purpose is to neutralize any pre-existing odors from detergents and remove manufacturing residue from the CPAP mask, hose, and reservoir. This pre-wash is essentially fragrance-free dish soap and should be used in the same manner as regular dish soap for washing CPAP components.
Users may occasionally experience a strong odor after using the SoClean, especially during the first use or with new equipment. This odor is a byproduct of the oxidation process and will decrease over time. Running the CPAP for 10 minutes before use or temporarily increasing the cleaning time can help mitigate this.
If the SoClean displays a "hose not present" message, it could be due to a missing side slot plug or a CPAP hose diameter that is not thick enough to engage the switch when the lid is closed. In the latter case, an acrylic sleeve may be needed to thicken the hose diameter.
For the SoClean 2 Go model, a red LED light indicates that the batteries need to be replaced, and all batteries should be changed simultaneously.
While the SoClean sanitizes, it does not remove facial oils. If a yellowish residue appears on the mask, it is likely built-up facial oils, not deterioration from ozone. The mask should be washed with the pre-wash or fragrance-free dish soap to remove this residue.
The SoClean is warranted for two years, with manufacturer testing simulating over 5 years of use without issues, indicating its durability.
General| Model | SC1200 |
|---|---|
| Cleaning Method | Ozone |
| Product Type | CPAP Cleaner |
| Power Source | AC Adapter |
| Compatibility | CPAP |
| Type | Automatic Cleaner |
| Product Name | SoClean 2 |
| Technology | Activated Oxygen |
| Voltage | 120V |
