SoClean Celios G200

8
Celios Technology brought to you by SoClean
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INFORMATION
WARNING: To reduce the risk of fire or electric shock, do not
use this fan with any solid-state speed control device.
WARNING: Unplug or disconnect the appliance from the power
supply before servicing.
WARNING: The appliance is only to be used with the power
supply unit provided and it must only be supplied at safety extra
low voltage, corresponding to the marking on the appliance.
WARNING: NOT SUITABLE FOR USE WITH SOLID-STATE SPEED
CONTROLS.
DO NOT operate any fan with a damaged cord or plug. Discard
fan or return to an authorized service facility for examination
and/or repair.
DO NOT run cord under carpeting. Do not cover cord with
throw rugs, runners or similar covers. Do not route cord under
furniture or appliances. Arrange cord away from the traffic area
and where it will not be tripped over.
DO NOT allow children to operate the G200 or play near the G200.
DO NOT operate if the power cord is damaged. Only plug the
power cord into a standard electrical outlet.
DO NOT use outdoors.
DO NOT immerse the G200 in liquid and do not handle the G200
with wet hands.
DO NOT insert a finger or foreign object into the airflow openings.
DO NOT use the G200 in toxic or explosive environments or
where flammable or combustible gases are present.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: The user is cautioned that changes or modifications
not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.