The vehicle has no electricity,
and the start button does not
shine
Error Causes Solutions
1. Battery is poorly connected
1. Connect the power cable appropriately
2. Circuit protector switch is not
turned on
2. Turn on the circuit protector switch
Power on,
turning accelerator，
motor not run
Speed is too slow or mileage
is too short
Battery cannot be charged
Low battery power
SIide stand is on
At parking mode
Brake lever does not reach the
right position
Accelerator error
The controller plug is loose
Controller error
Low battery power
Flat Tyre
Heavily overloaded
Brake pads need to be replaced
Battery aging or normal scrap
1.
2.
3.
4.
5.
Poor contact of charger plug
Used wrong charger
Battery aging or normal scrap
1.
2.
3.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
Charge the battery
Kick the side stand out
Press parking button
Place the brake lever at the right position
Change accelerator
Re-plug controller
Change controller
Charge the battery
Pump up the tire, check tire pressure before riding.
Foster a good habit, keep an appropriate load
Change the brake pads and check the brake system
before riding
Change battery
1.
2.
3.
Check whether the battery plug is at right position or not
Use SUPER SOCO charger
Change the battery
a. FAQ & Troubleshooting
FAQ& TROUBLESHOOTING
25
To Next Page
Loading...
