FAQ & TROUBLE SHOOTING
Error Causes Solutions
Regular maintenance can enhance the service life and driving safety of TC. Please refer to the following suggestions and take care
of your motorcycle.
1.Battery is poorly connected
2.Kill switch is not turned on
1.Connect the power cable appropriately
2.Turn on the kill switch
1.Low battery
2.Side stand is on
3.At parking mode
4.Brake handle does not reach the right position
5.Throttle error
6.The controller plug is loose
7.Controller error
1.Charge the battery
2.Side stand off
3.Press parking button
4.Place the brake handle at the right position
5.Change throttle
6.Re-plug controller
7.Change controller
1.Low battery
2.Flat Tyre
3.Heavily overloaded
4.Brake pads need to be replaced
5.Battery aging or normal scrap
Charge the battery
Pump up the tyres, check tyre pressure before riding
Foster a good habit, keep an appropriate load
Change the brake pads and check the brake system
before riding
Change battery
1.Poor contact of charger plug
2.Used wrong charger
3.Battery aging or normal scrap
1.Check whether the plug is at right position
2.Use SOCO charger
3.Change battery
No power, “POWER” not on
Power on, turning throttle,
motor not work
DAILY CLEAN AND MAINTENANCE
Speed is slow or mileage
is short
Battery cannot be charged
1.
2.
3.
4.
5.
To Next Page
Loading...
