SodaStream JET - Setting Up Your SodaStream Jet; Installing the CO2 Cylinder; Compatible Cylinder Types

SET UP
INSTALLING THE CO
2
CYLINDER
SODASTREAM
®
CO
2
SCREW SYSTEM CYLINDER
1. Place the SodaStream
®
Jet
TM
Sparkling Water Maker
on a flat sturdy surface and remove the back cover.
2. Remove seal and cap from the SodaStream CO
2
Cylinder. WARNING! Never insert or replace the CO2
Cylinder while a Carbonating Bottle is installed in
the Sparkling Water Maker. This can cause the
Carbonating Bottle to burst. Tilt the Sparkling Water
Maker forward and insert the CO
2
Cylinder in the back of
the Sparkling Water Maker.
Gently raise the CO
2
Cylinder and tighten by turning to
the right until it is firmly held in place. WARNING!
Hand-tighten only. DO NOT use tools; this can
damage the Sparkling Water Maker or CO
2
Cylinder.
This may result in an uncontrolled flow of CO
2
gas,
causing the Carbonating Bottle to burst and result in
personal injury or property damage.
3. Reinstall the back cover. Now you are ready to create the
bubbles.
Please note that the
SodaStream
®
Jet
TM
is
compatible with the
SodaStream
®
CO
2
Screw
System Cylinder and is NOT
compatible with the
SodaStream
®
Quick Connect
Cylinder.
1
3
COMPATIBLE SODASTREAM
®
CO
2
SCREW SYSTEM CYLINDER
NON-COMPATIBLE
CO
2
QUICK CONNECT CYLINDER
Use Only SodaStream
CO
2
Screw System Cylinder
4
3
2
1