What to do if Soehnle Touch terminals show only upper horizontal lines indicating overload?
If your Soehnle Touch terminals display only the upper horizontal lines, it means the maximum weighing range has been exceeded. To resolve this, remove some of the product from the scale.
Why do Soehnle 3010 display --0-- after automatically setting zero?
If your Soehnle Touch terminals display '--0--' after being switched on and automatically setting to zero, it indicates the scale is outside the set tolerance band. You can try clipping off the platform and removing any soiling. If the scale still fails to display zero after a few seconds, please inform your service partner.
What to do if Soehnle 3010 show only lower horizontal lines indicating underload?
If your Soehnle Touch terminals display only the lower horizontal lines, it indicates an underload condition. To fix this, switch the scale off and then back on again to reset the zero point automatically.
What to do if Soehnle Touch terminals display an error message about part weight being too small?
General| Brand | Soehnle |
|---|---|
| Model | 3010 |
| Category | Touch terminals |
| Language | English |
To Next Page
