What to do if Soehnle Touch terminals show only upper horizontal lines indicating overload?
If your Soehnle Touch terminals display only the upper horizontal lines, it means the maximum weighing range has been exceeded. To resolve this, remove some of the product from the scale.
Why do Soehnle 3010 display --0-- after automatically setting zero?
If your Soehnle Touch terminals display '--0--' after being switched on and automatically setting to zero, it indicates the scale is outside the set tolerance band. You can try clipping off the platform and removing any soiling. If the scale still fails to display zero after a few seconds, please inform your service partner.
What to do if Soehnle 3010 show only lower horizontal lines indicating underload?
If your Soehnle Touch terminals display only the lower horizontal lines, it indicates an underload condition. To fix this, switch the scale off and then back on again to reset the zero point automatically.
What to do if Soehnle Touch terminals display an error message about part weight being too small?
In case of error messages about part weight being too small, zeroing limit overshot or undershot, it is impossible to tare an unloaded scale or print in underload or overload, please contact your service partner.
Notes on the operating manual, references for further information, and potential deviations.
Details the technical specifications and features of the Basic Terminal 3010.
Instructions for safely connecting and setting up the appliance before initial use.
Guidance on physically installing the weighing platform and the terminal.
Explanation of the various symbols displayed on the terminal screen.
Details the information provided on the scale's identification plate.
Overview of the functions of each key on the appliance in different modes.
Describes how to access and interpret the digital information displayed on the terminal.
Procedure for turning the scale on and its initial state.
Instructions on how to properly turn off the appliance.
How to correct minor zero deviations caused by soiling or drift.
Procedure for changing the displayed unit between kilograms and pounds.
Explanation of manual, auto, and provisional tare functions.
How to activate the display with increased resolution.
Method for toggling between different analogue measuring points.
Information on accessing and managing the alibi memory records.
How to freeze the displayed weight value in various modes.
Configuration of optional I/O modules for inputs and outputs.
Functionality and activation of integrated LED indicator lamps.
Basic operation of weighing and applying tare.
Using the scale for piece counting operations.
Functionality for accumulating weight values in a total memory.
Using the scale for accumulating weight values in a batch memory.
Procedure for weighing removed product with negative display.
Setting up thresholds for switching and dosing.
Using switching points for checking operations, e.g., tolerances.
Instructions for setting up and performing dosing operations.
Interpreting common display indicators and error codes like --0-- or overload.
Explanation and remedies for specific error codes (Err 04 to Err 08).
General| Brand | Soehnle |
|---|---|
| Model | 3010 |
| Category | Touch terminals |
| Language | English |
To Next Page
