To prevent accidental activation during storage or transportation, unscrew the head by half a turn or
remove battery.
Every 6 months threads should be wiped with a clean cloth followed by a thin layer of silicone grease.
To maintain a proper level of waterproofness, replace worn-out o-rings with an approved spare (2
pieces are shipped with initial order).
Troubleshooting: Cleaning battery contacts regularly as dirty contacts may impair the performance of
the flashlight. If you experience problems (flicker, shine intermittently or failure turn on) the
following root causes and solutions should be tried:
Reason A: The battery needs replacement (Battery voltage is below 2.8V).
Solution: Replace battery with an approved type of fully charged battery.
Reason B: Threads, PCB board contact or other contacts are dirty.
Solutions: Please clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods do not work please refer to the warranty policy before contacting your authorized
distributor.
Sofirn Limited:
Tel: +86-755-23440047 Fax:+86-755-23440141
Web: www.sofirnlight.com
E-mail: us@sofirnlight.com eu@sofirnlight.com
Please contact us if you have any questions.
If your product is defective please contact us for replacement within warranty period.
Manufacturer: Shenzhenshi Jinba Technology Co.,Ltd
Address: 1/F to 9/F, 1st Building, NO.110 Tenglong Industrial Center, Guanlan Street, Longhua New
District, Shenzhen 518000, China
To Previous Page
Loading...
