Adjusting the disc brake and drum brake
If the brake is too tight, loosen the pressure plate screw with a 5 mm Allen wrench by turning it counterclockwise. Shorten the length of the brake wire (behind the
screw you loosened) to loosen the brake and then retighten the screw. If the brake is too loose, loosen the screw and pull on the brake wire to lengthen the wire.
Then tighten the screw again.
Note: You can find more instructions and tips and tricks on Youtube.com under SoFlow.
To pump up the tyres
If the tyres start to lose pressure or have too little a
ir in them from the start, you should inflate them to 2.5 bar.
To Next Page
Loading...
