copyright by www.soflow.com 5/48
1.2. Setting up your new Scooter
Your new SoFlow scooter has been thoroughly checked and
part-assembled by our technicians.
It’s almost ready to ride – just follow these simple set-up
instructions and you’ll be ready to go!
Watch the SOFLOW video on
setting up your e-scooter
Remove the protective packaging but do
not lift the scooter out of the cardboard
frame just yet. Lift the stem until it clips
upright into the frame.
Pull down the latch mechanism until it clips
securely.
Warning!
Do not ride the scooter if the latch is loose.
You can charge your e-scooter by plugging
the charging cable into the charging port.
Once fully charged the charger light will
change from red to green.
. Check the tire pressure
Make sure both tires are inflated with the
pressure as recommended as follow:
Driver weight Tire pressure
60-75kg 3,5bar / 50.5psi
75-90kg 3,7bar / 53.6psi
90-110kg 4,0bar / 58psi
110-120kg 4,3bar / 62.3psi
To Next Page
Loading...
