18
3.5 Maintenance
Do not try to charge the SO6 when the battery is already full. This could diminish the battery’s capacity in the long run.
Check all screws before using the SO6, especially those of the handle bar, the brakes and the front- and rear wheel. Ensure
that all screws are tightened before you use the SO6.
Thoroughly clean the SO6 with a dry cloth after usage. The front and rear ball bearings must be lubricated from time to
time. Ordinary bicycle oil can be used. Oil the area where the axle runs into the wheel to ensure better durability.
To Next Page
Loading...
