EN
a. ON/OFF switch
b. Temperature control switch
c. Automatic safety shut-off pilot light
d. Temperature display screen
INSTRUCTIONS FOR USE
• Make sure that all products’ packaging has
been removed.
• This appliance has been designed exclusively
use it for any other purpose.
• Spread the pad out fully, making sure it’s not
folded or creased.
• Unroll the cable completely before plugging it
in.
• Ensure that the electronic connector is proper-
ly attached to the appliance.( Fig. 1).
• Connect the appliance to the mains.
• The display screen (d) and the automatic shut-
off pilot light (c) will light up for a moment (Fig.
2).
• Turn the appliance on, by using the on/off switc
(a).
• The display screen will light up (d) and show
temperature position 1.
•
fer to section
Troubleshooting (Fig. 3).
• Press the temperature control button (b). It will
start at level 1. Continue to press the button to
increase the temperature up to the maximum
level 4 (CT8635 – CT8639) or 6 (CT8680 –
CT8690) (Fig. 4).
• As a security measure, the appliance is pro-
grammed to turn off automatically after 120
min (CT8635- CT8639) and 90 min. (CT8680
– CT8690) of continuous use. If the appliance
is stopped in this way, press the power switch
again to reheat.
• Select the desired temperature
-
• Turn the appliance off, using the on/off switch
(a).
• Unplug the appliance from the mains.
• Clean the appliance.
• If the letter F appears on the display screen,
proceed as follows:
• Check that the power cable connector (4) is
correctly inserted into the pad connector (5).
If not, press the ON/OFF button (a) and insert
it correctly.
• Check that the operating failure is not caused
by overheating. To do so, press the ON/OFF
button (ai) and allow the pad to cool. Find out
what is causing the pad to overheat and elimi-
nate the cause.
• If the appliance stops working, contact an au-
thorised technical service.
CLEANING
• Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
• Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
• Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
• The pad may be washed by hand in warm
water (CT8680) and by machine (CT8635,
CT8639, CT8690) at a temperature of up to
30ºC. Remove the control before washing (Fig.
1). The control must never be submerged in
water.
• Dry the product immediately after any clean-
ing task making sure that the appliance inlet is
perfectly dry.
• The pads (CT8635, CT8639) have a remova-
ble cover that can be washed by hand or ma-
chine at a temperature that does not exceed
30 ºC.
• Do not use the pad if the removable cover is
not completely dry.
• Never submerge the connector in water or any
other liquid or place it under running water.
• It is advisable to wash the cushion and cov-
er only if they are dirty or dusty. If washed too
often the product could wear out vey quickly.
• Let the appliance cool down before putting it
away.
• When the appliance is not in use, keep in a dry
place and avoid placing heavy objects on top
as they could damage the cables.
• Avoid creases forming. Check the appliance
and power cord frequently to make sure they
are in perfect condition.
To Next Page
Loading...
Need help?
General
