19
C) ADJUSTING THE AMOUNT OF WATER FOR 2 ESPRESSOS
Sequence Press the button Message on screen
1. The coffee-maker is ready.
2. Press the ‘P’ button to enter the programming menu.
3. The first programme is for adjusting the amount of water per cup.
You can programme the amount for each type of coffee you can
obtain. To help you, the four possibilities will begin to flash.
4. To programme the amount of water for 2 espresso coffees, press the
corresponding button.
5. After pressing the button for 2 espresso coffees, you enter the menu
for programming the amount of water.
Press the ‘arrow’ to increase the amount of water by 10 ml from 30 ml
to 60 ml.
By default, the coffee-maker is programmed with 40 ml for each cup
of espresso coffee.
6. To confirm your selection, press ‘P’.
To exit the programming mode, press ‘Esc’.
7. The coffee-maker is ready.
To Next Page
Loading...
