1. The jug & base: Clean the jug immediately after each use,flush and clean the wall and bottom
with warm soapy water and use the brush to clean the residue if there is,Never use sharp object such as
metal brush and never use abrasives cleaning agent to clean the surface to avoid scratches. Then dry
with a soft cloth.
2. The lid: Rinse under water directly.
3. The whisks: Remove from the jug and wash with warm water. Dry and store in a safe place in case of missing.
SPECIFICATION
Rated Voltage: 110-120V Rated Frequency:
60Hz
Rated Power:
500W N.W./G.W.: 1.65 pound / 1.94 pound
Capacity： 5.3 ounces for Heating and frothing
10.6 ounces heating
Protection Class: I
Product Size: 8.11 x 5.9 x 4.29 inches
TROUBLES SHOOTING
Problems Causes Solutions
Indicator light doesn’t
work or jug doesn’t
work
Plug is not inserted properly Re-insert into the power
Jug and power base not connected properly Remove the jug and place again on the base
No power in the socket Check the electric circuit
Problems with electric elements Repair
Jug ceases to work
after starting operation
Jug temperature is too high
Rinse cold water inside the jug to reduce the
temperature
Jug damaged with immersion in water repair
Motor doesn’t work
Jug is not cleaned in time after use, milk
locks the mechanism
Clean and move the shaft sleeve of motor by
hand to loosen it
Motor damage repair
No heating Machine damage repair
Charring
Dosage of milk either too little or too much Use the dosage of milk according to the dial
Jug reused without cleaning Cleaning in time after use
Actual voltage much lower than specified
voltage
Use the appropriate voltage
Quality of milk froth not
up to standard
Wrong milk type or temperature
Make sure to use whole or semi-skimmed
milk at refrigerator
temperature (about 6-8 °C)
Wrong whisk used Make sure to use the appropriate whisk
Jug reused without cleaning Make sure the jug is clean
To Previous Page
Loading...