solamagic IR 02004 - Initial Operation; Cleaning Instructions


104

The heater must be connected to the mains. For those models without a wall or pull
switch, heating starts as soon as the plug is plugged into the socket. For models
with a wall or pull switch or a wireless switch, heating starts when the switch is
turned on or via the remote control.
If necessary see also the separate operating instructions for the remote control.

• Disconnect the heater from the mains.
• Allow the casing to cool.
• Wipe the casing clean with a moist, soft cloth. Do not use any detergent.












Switch activation
1x – Light on/heat off
2x – Light off/heat on
3x – All on
4x – All off
L = Brown
N = Blue
WS = Radiant heater
EBS= Recessed downlight
„All in one“ wiring diagram