SOLARFOCUS Therminator II

Other manuals for SOLARFOCUS Therminator II

Questions and Answers

K
Katelyn ObrienAug 12, 2025
What to do if SOLARFOCUS Therminator II combustion stopped?
- H
  hernandezkimberlyAug 12, 2025
  If the combustion in your SOLARFOCUS Boiler has stopped, there might be several reasons: * Multiple temperature limit violations: Check the buffer cylinder temperature before igniting and only supply as much fuel as required. * Fault in circulation pump: Inspect the pumps/mixers using the screen Output test. * Pump/mixing valve is not electrically connected. * Air in the pump/line: Bleed the system. * Too low pressure: Check the pressure and bleed the system.
P
Paul FernandezAug 16, 2025
What to do if I get a 'Heat exchanger blockage' warning on my SOLARFOCUS Therminator II?
- D
  Dustin JohnsonAug 16, 2025
  If you receive a 'Heat exchanger blockage' warning on your SOLARFOCUS Boiler, it could be due to: * Insufficient boiler cleaning, such as ash accumulation below the heat exchanger turbulators: Remove the ash from the combustion chamber all the way to the rear. * Fuel not complying with specifications, potentially causing deposits on the heat exchangers. * The boiler often working in partial load operation, frequently triggering the overtemperature reset (STB): Check the buffer cylinder temperature before refilling and only supply as much fuel as required.
R
Roger FrenchAug 19, 2025
Why does the Safety Temperature Limiter (STB) trip in my SOLARFOCUS Therminator II?
- Y
  ywheelerAug 19, 2025
  The Safety Temperature Limiter (STB) in your SOLARFOCUS Boiler might trip due to excessively low energy take-up. To resolve this, check the buffer cylinder temperature before refilling and only supply as much fuel as required.
G
gwardAug 23, 2025
What to do if there is an ignition fault with the automatic log wood function on my SOLARFOCUS Therminator II?
- V
  virginiacraneAug 25, 2025
  If you're experiencing an ignition fault with the automatic log wood function on your SOLARFOCUS Boiler, consider the following: * Defective fuel filling: Refer to description of operating mode > 7 Operating mode Logs automatic > 20. * Filling chamber or combustion chamber door not closed properly: Ensure they are securely closed. * Sediment in the mouth of the ignition pipe (in the filling chamber): Perform a visual inspection and clean if necessary. * Insufficient boiler cleaning.
A
Amanda MccoyAug 27, 2025
What to do if the operating pressure in my SOLARFOCUS Boiler heating system is too low?
- S
  samantha09Aug 27, 2025
  If the operating pressure in your SOLARFOCUS Boiler heating system is too low, it may be caused by air in the line system. Check the pressure and bleed the system.
A
alison41Aug 31, 2025
What happens if the door is open on my SOLARFOCUS Therminator II Boiler?
- L
  Lisa RubioAug 31, 2025
  If the cladding door of your SOLARFOCUS Boiler is open, the burner will stop the burn process when the time is exceeded. The remaining time is shown on the display.
D
David SloanSep 3, 2025
What happens if the door is open and there is a heating request on my SOLARFOCUS Therminator II?
- K
  Karen MillerSep 3, 2025
  If the cladding door of your SOLARFOCUS Boiler is open, the burner will not start even if there is a heating request.
D
dcarterSep 8, 2025
What to do if there is a power failure during operation of my SOLARFOCUS Boiler?
- S
  Sheila OrtegaSep 8, 2025
  If you experience frequent power failures during the operation of your SOLARFOCUS Boiler, contact qualified personnel, as the cause may be a defect in the electrical power line or distributor.