X1/X3-EVC Series 7.2 kW-22 kW
(Commercial Edition)
Packing List
Installation Steps
STEP 1: Remove the screw from the EV-Charger with the cross screwdriver. Then remove the back bracket away carefully.
STEP 2: Fix the back bracket and the cable hook (only for Plug Type) to the wall.
- Mark the position of the holes.
- Drill holes with φ 8 drill.
- Depth: at least 45 mm.
- Insert the expansion bolts.
- Align the bracket and the cable hook (only for Plug Type)
with the holes, and screw the self tapping screws with the
cross screwdriver.
STEP 3: Hang the EV-Charger on the wall for trial, then estimate the required length of input cable (three-core for single-phase, five-core for
three-phase, outer diameter: 12.5-18 mm) and communication cable. After that, take the EV-Charger down.
STEP 4: Unscrew the EV-Charger’s rear cover with the cross screwdriver and take it down. the fastening heads and take the Then undo
waterproof materials away as shown below.
STEP 5: Unscrew the countersunk screw of the base plate of communication board with the cross screwdriver. Then pull the base plate of
communication board out.
Cable hook *1
(only for Plug Type)
Expansion bolt *3/5
(3 for Socket Type,
5 for Plug Type)
European terminal *3/5
(3 for single-phase;
5 for three-phase)
Self tapping screw *3/5
(3 for Socket Type,
5 for Plug Type)
Gasket *3/5
(3 for Socket Type,
5 for Plug Type)
≥400 mm
(torque:1.5~2 N·m)
EV-Charger *1
②
①
Documents
Private RFID card *2
To Next Page
Need help?
General
