System On
(Flashing - No Flow)
Check Manual
or Our Website
www.solaxx.com
PRECISION
PRECISION
System On
(Flashing - No Flow)
Check Manual
or Our Website
www.solaxx.com
PRECISION
PRECISION
1. CHLORINE FROM CHEMICALS OR SALT SYSTEMS ARE NOT A PROBLEM AND THE SYSTEM MAY
BE STARTED WHILE USING CHLORINE.
2. Test pool water and adjust pH, total alkalinity and calcium hardness levels before starting system. See
Table below.
POOL WATER PREPARATION
OPERATION
WARNING: DO NOT ATTEMPT TO
OPEN THE POWER SUPPLY FOR ANY
REASON. IT IS SEALED AND NOT
DESIGNED TO BE REPAIRED IN THE
FIELD. A DEFECTIVE OR NON
FUNCTIONING POWER SUPPLY IS
REPLACED WITH A NEW UNIT ONLY.
- Steady Blue LED = system has power and is
operating normally
- Flashing Blue LED = no flow to chamber. This
could be caused by the pool pump losing its
prime or from blockage in the plumbing. Check
water flow through system.
Note: The flow is determined using a
temperature sensor. Therefore, it may take a
few minutes to recognize that flow has
stopped when the system turns off. This is
not harmful to the Precision chamber.
- Steady Red LED = system error. This means
an error has occurred in the power supply.
Please go to www.solaxx.com to create an RMA
form which will be answered within 24 hours or
next business day to resolve this issue.
System On
(Flashing - No Flow)
Check Manual
or Our Website
8
To Next Page
Loading...