Solem WooBee - Sensor Wiring; Water Meter Wiring; Technical Specifications

WATER METER
WaterMeter
+ S - C P 1 2 3
Red wire -> + Black wire - > -
If your pulse sensor is polarized, then
observe the polarity when wiring :
SENSOR WIRING
WooBee has a sensor input + S - to connect a rain sensor
or a water meter pre-equipped with a pulse sensor, only congurable
with the mobile applicaon MySOLEM. By default, the sensor input
is congured for the rain sensor. To change the sensor, with the
applicaon, delete the acve sensor.
+ S - C P 1 2 3
OPERATION :
Bluetooth® Smart 4.0 Low Energy
Frequency band used and maximum emied
power: [2400-2483.5]Mhz, 1mW
Permanent backup of the programs
Backup of the internal clock in case of
power failure < 30 seconds
TECHNICAL SPECIFICATION
SPECIFICATIONS :
100% waterproof (IP68 rated)
Rain sensor or Water meter connecon
Master valve connecon
9V latching solenoid compable
Maximum wiring length with solenoids: 30 m
Operang temperature: -10°C to 50°C
2 years warranty
POWER SUPPLY :
9V 6AM6 or 6LR61 alkaline baery
or 4 x 1.5V AAA alkaline baeries
DIMENSIONS :
Widht : 10.5 cm (3.94 inch)
Length : 15 cm (5.90 inch)
Thickness : 5 cm (1.97 inch)
The symbol «CE» indicates that this device complies with the European standards on safety, health, and
environment and user protecon. Devices with the symbol «CE» are intended for sale in Europe.
This symbol indicates that these types of electrical and electronic equipment must be disposed of separately
in European countries. Do not dispose of this device with your household waste. Please use the collecon and
recycling points available in your country when you no longer need this device.
This symbol indicates that the product uses a Bluetooth® technology
5
6
This symbol indicates that the product is waterproof
This symbol indicates that the product is resistant to ultra violet
This symbol indicates that the product is shock resistant