What to do if Soleus Air MA-9000AH Air Conditioner is leaking water?
If your Soleus Air Air Conditioner is leaking water, ensure the unit is placed on a level surface. Also, check that the drainage plug is properly secured and plugged.
How to fix a blinking 'Water Full' indicator on Soleus Air MA-9000AH Air Conditioner?
If the 'Water Full' indicator is blinking on your Soleus Air Air Conditioner, it means either the water bucket is full, so you should empty it, or the water bucket is not installed correctly; in this case, completely insert the water bucket.
Why is my Soleus Air Air Conditioner not cooling the room?
Your Soleus Air Air Conditioner might not be cooling the room due to several reasons. There could be a heating source in the room; turn it down or off. The temperature setting might be too high; lower it. The air filter could be dirty; clean or replace it. The air exhaust might not be installed correctly; check the exhaust duct to ensure hot air is vented outside. The room might be too big, or too much sunlight might be entering; this unit cools rooms up to 300 square feet with standard ceiling height. Finally, there might be frost on the evaporator; the unit will defrost automatically.
What to do if my Soleus Air MA-9000AH does not operate?
If your Soleus Air Air Conditioner isn't operating, check these possible causes: ensure the unit is securely plugged into the power outlet. If the drain bucket is full, empty it. Make sure the water bucket is completely inserted. Remove any obstructions from the exhaust hose. Also, cancel the timer if it's on.
General| Type | Portable Air Conditioner |
|---|---|
| Cooling Capacity | 9000 BTU |
| Dehumidification | Yes |
| Power Supply | 115V/60Hz |
| Fan Speeds | 3 |
| Refrigerant | R410A |
| Coverage Area | 300 sq ft |
| Dehumidification Capacity | 50 pints per day |
| Operating Modes | Fan |
To Next Page