Introduction
The Levelogger
®
App Interface uses Bluetooth
®
wireless
technology to connect a Solinst datalogger to an Android™ smart
device running Android 4.4 or higher. Please see the list of tested
devices on the last page of this quick start guide.
Once the connection is made, you can use the Solinst Levelogger
App to interact with the datalogger. The Solinst Levelogger App
allows you to view real time data from the connected datalogger,
as well as view, download, and e-mail logged readings. You can
also program the dataloggers or apply a saved settings file.
The Levelogger App Interface works with the Levelogger Edge,
Barologger Edge, Levelogger Junior Edge, LTC Levelogger
Junior, Rainlogger Edge, and AquaVent, as well as the older
Levelogger Gold, Barologger Gold, Levelogger Junior, and
Rainlogger dataloggers.
Levelogger App Interface
Connection
The Levelogger App Interface connects to the top end of a
Levelogger’s Direct Read Cable or Adaptor, or to an AquaVent
Wellhead Connector Cable.
To connect the App Interface to a Direct Read/Connector Cable,
simply hold onto the top end of the Direct Read/Connector Cable,
and thread the coupling of the Levelogger App Interface onto the
Direct Read/Connector Cable. This connection is designed to be
stable when the Direct Read Cable is installed in a Solinst 2" Well
Cap Assembly for Leveloggers.
To connect to the Direct Read to Optical Adaptor, thread the
Levelogger App Interface to the end of the Adaptor as described
above. Line-up the optical eyes and thread the other end of the
Adaptor onto the Levelogger. A slip fit version is also available.
Battery Access
Connection to
Direct Read/
Connector Cable
or Adaptor
Direct Read Cable with Levelogger
Direct Read to
Optical Adaptor
AquaVent Wellhead and
App Connector Cable
To Next Page
Loading...