145144
GB GB
NOTE: When the espresso machine is used in a normal way, the life cycle of
the water filter is 2 months. If the machine is only used irregularly or not at all
while the water filter is installed, the life cycle is only 3 weeks!
●
To start using the water filter, let at least half a litre of cold tap water run through
the opening of the water filter, until water escapes from the openings on the
side for at least one minute.
●
Take the rinsed water tank off of the appliance, fold open the lid towards the
curved side of the tank and fill the water tank with cold tap water up to the
MAX marking.
●
Submerge the water filter in the tank: It should be fully submerged in water for at
least 10 seconds. Slightly tilt the water filter towards one side and gently squeeze
the water filter so that the remaining air can escape.
●
Now, install the water filter into the designated bracket on the bottom of the
water tank with the blue date cap facing upwards. Push the water filter down to
make sure that it is properly installed.
●
Close the tank lid and place the water tank on the back of the appliance with
both hands so that it slides down both guide rails, lying flat against the back of
the appliance.
.
To Next Page
Loading...
Need help?
General
