GB GB
6160
s
BEFORE FIRST USE
●
Before using your multigrater for the first time, remove all potential stickers and
labels (apart from the type plate).
●
Disassemble the appliance as described in the chapter “Disassembling the
Multi grater” (see page 63).
●
Rinse all parts of the multigrater apart from the motor unit with warm water
(not above 50 °C) and some detergent. Make sure not to hurt yourself on the
sharp grating blades in the cutting drums. Best use a dishwashing brush for the
cutting drums. Dry all parts carefully.
●
Wipe the motor unit clean with a soft, slightly moist towel.
●
When all parts are completely dry, reassemble the multigrater as described in
the chapter “Assembling the Multigrater”.
s
ASSEMBLING THE MULTIGRATER
STEP 1:
●
Place the motor unit on a smooth, dry, stable, moisture resistant and even work
surface, near a power outlet.
STEP 2:
●
Choose a suitable cutting drum. Push the cutting drum into the holder from
behind, until it touches the front end of the holder.
STEP 3:
●
a) Place the cutting drum holder in the motor unit, the funnel has to positioned
at 1 o'clock.
b) Then, turn the funnel in a counter clockwise direction (towards “Lock”) into
the 12 o'clock position, so that it audibly locks into place.
q
a) b)
To Next Page
Loading...
Need help?
General
