GB GB
6564
s
CLEANING AND MAINTENANCE
●
The appliance should be cleaned after every use.
●
Before cleaning, switch the appliance off with the ON/OFF toggle switch (posi-
tion 0), wait for the appliance to come to a stop and pull the plug.
●
Disassemble the appliance as described in the chapter “Disassembling the
Multi grater” (see page 63).
●
Caution: The grating blades in the cutting drums are very sharp!
●
All removable parts can be cleaned in water, the motor unit however must never
be submerged in water or any other liquid.
●
You can clean the removable parts in warm (not above 50 °C) dish water with
a sponge resp. clean the cutting drums with a dishwashing brush. After that,
dry all parts carefully.
●
Clean the motor unit with a slightly moist towel and some mild detergent.
●
Make sure that all parts are completely dry before reassembling the appliance.
●
In general, do not use any aggressive or scouring detergents or metal sponges,
as these might damage the surface.
s
STORAGE
●
Check, if the appliance is disconnected from the power and clean and dry.
●
Best store the appliance fully assembled and in an upright position in a dry, dark
space, best in the original packaging. Do not place anything on the appliance.
●
The 4 cutting drums that are not installed into the appliance can be safely and
hygienically stored in the two storage containers – two cutting drums fit into
each of the containers.
●
Always keep the appliance and the power cord out of the reach of children.
s
TECHNICAL SPECIFICATIONS
Model no. FB-333A, Type 8401
Product description Electric Multigrater
Voltage / Frequency 220–240 V~ / 50 / 60 Hz
Output 350 Watts
Rotation 160 rpm (setting I) / 180 rpm (setting II)
Specifications approx. 13,0 x 30,0 x 19,0 cm (W@H@D)
Weight approx. 2,08 kg
Technical changes reserved.
To Next Page
Loading...
Need help?
General
