GB
4
Connect your arrest system to the
Xenon carriage mobile handle.
Make sure that the carabiner is
closed and locked (see carabiner
manual).
Take the carriage in the palm of the hand,
press the release button with the thumb
and simultaneously press on the back of
the carriage. Do not pull on the handle
because it will cause the carriage to close
again.
The carriage will open a
few millimeters to allow
the cable to be inserted.
Place the carriage over
the cable.
Release the carriage. It will close
automatically on the cable. The
handle will be in the free position
permitting work 180° either side
of the lifeline.
INSTALLING THE MOBILE CARRIAGE
1
2
3
4
Never use acid or alkali solvents.
· Allow to dry in a ventilated place
away from any direct flame or
any other source of heat. Avoid
corrosive, dusty, overheated or
refrigerated atmospheres.
TRANSPORT
During transport, make sure the
open carriage is stored away from
any corrosive atmosphere,
mechanical shock, etc.
notice Xenon-6 langues.qxd 21/01/02 11:37 Page 5
To Next Page
Loading...