To Next PageTo Next Page
Need help?Do you have a question about the Solo 117 and is the answer not in the manual?
General| Fuel Tank Capacity | 0.5 l |
|---|---|
| Engine Type | 2-stroke |
| Shaft Type | Straight |
| Handle Type | Loop |
| Starter System | Recoil |
General safety instructions and precautions for brushcutter operation.
Mandatory protective gear for safe brushcutter operation, including head, eye, hand, and hearing protection.
Instructions on how to properly operate the brushcutter safely and effectively.
Procedure for adjusting the carburetor for optimal engine performance.
Maintenance and cleaning instructions for the air filter to ensure engine efficiency.
Lubrication requirements for the gear head, including type and interval.
Details on the correct fuel mixture (gasoline and oil) for the 2-cycle engine.
Step-by-step guide for starting the brushcutter engine.
Instructions for assembling and adjusting the loop handlebar.
How to adjust the bicycle handlebar for optimal user ergonomics.
Steps for installing the debris shield for user protection.
Guide on how to install and switch between different cutting attachments.
Detailed steps for starting and stopping the brushcutter engine.
General instructions and safety precautions for brushcutter assembly and use.
Essential protective gear required before operating the brushcutter.
Warning about poisonous exhaust gas and need for ventilation.
Guidance on using approved cutting tools and debris guards.
Recommended technique for optimal cutting and safe operation.
Identification of the three adjustment needles for the carburetor.
Step-by-step guide for correctly adjusting the carburetor.
Procedure for checking and cleaning the air filter.
Explanation of how soiled air filters affect engine performance.
Details on spark plug identification, type, and required electrode gap.
Information on the special gear grease and lubrication intervals.
Recommendation to check accessible screws and nuts after initial operation.
Instructions for inspecting and maintaining cutting tools.
Precautions for transporting the brushcutter, including engine status and blade protection.
Attention needed to prevent fuel spillage during vehicle transport.
Details on the 2-cycle engine's requirement for a gasoline and oil mixture.
Recommended gasoline/oil ratios for different types of 2-cycle oil.
Advice for the first few tankfuls regarding engine load and oil ratio.
Safety measures to follow when refueling, including avoiding open flames and vapors.
Guidelines for storing the brushcutter in a dry area and emptying the fuel tank.
Steps to attach and adjust the loop handlebar for balance and comfort.
Procedure for installing the upper grip support onto the lower grip support.
How to adjust the handlebar for correct body alignment and arm position.
Instructions for attaching the debris shield assembly on Model 117.
Steps for attaching the debris shield with metal blades on Models 121/129.
Procedure for installing a thread cutter attachment with a securing bolt.
Instructions for installing and exchanging cutting attachments on Model 117.
Instructions for installing and exchanging cutting attachments on Models 121/129.
Method for advancing the trimmer line by tapping the head on the ground.
How to adjust the carrying strap for proper balance and operational control.
Step-by-step guide for starting the engine with a loop handlebar.
Detailed steps for starting the engine from cold or after a brief cut-off.
Procedure for starting the engine when it is already warm.
Instructions on how to safely stop the brushcutter engine.
Instructions on how to detach the shaft assembly from the brushcutter.
Specified idling and maximum admissible engine speeds for models.
Technical details on engine type, capacity, and maximum RPM.
Sound pressure and sound capacity levels according to standards.
Medium values of oscillation acceleration on handles.
Weight of the brushcutter without cutting attachments.
Schedule for checking and adjusting the carburetor.
Schedule for cleaning and replacing the air filter.
Schedule for adjusting and replacing spark plugs.
Schedule for checking and replenishing gear lubrication.
Schedule for checking screws, cutting blades, and grips.
