Solo 153 User Manual

1
Diese Anweisung ergänzt die Gebrauchsanweisung für SOLO Freischneider 134/140
bzw. 132/141 bei Ausrüstung mit 2-Takt-Motor 52 cm
3
Supplementation to instruction manual for SOLO Brushcutters 134/140
resp. 132/141 with 2-stroke-engine 53 cc.
Supplément du manuel d'instructions SOLO débroussailleuses 134/140
et 132/141 avec moteur 2-Temps 52 cm3.
Suplemento al instrucion de manejo para SOLO-Desbrozadoras 134/140
resp. 132/141 con motor de 2 tiempos de 52 cc.
Gebrauchsanweisung
Instruction manual
Instructions d'emploi
Manual del usario
9 152 105 08/05
152 / 153
Achtung: Lesen Sie vor der ersten Inbetriebnahme diese
Gebrauchsanweisung gründlich durch und beachten Sie
unbedingt die Sicherheitsvorschriften!
Important: Read this instruction manual carefully before first
operation and strictly observe the safety regulations!
Attention: Lire attentivement ce manuel avant la première mise en
service et observer absolutement les prescriptions de sécurité!
Atención: Es indispensable leer con mucha atención las
instrucciones de manejo antes de utilizar por la primera vez.
¡Preste especial atención a las recomendaciones de seguridad!
Fig. A
1 Zündkerze
2 Startergriff
3 Kraftstofftank
4 Choke
5 Primer
6 Luftfilter
7 Dekoventil
Spark plug
Starter grip
Fuel tank
Choke
Primer
Air filter
Decompression valve
Bougie
Poignée lanceur
Réservoir de carburant
Bouton starter
Pompe d'amorçage
Filtre à air
Soupape
Buija
Empunadura de arranque
Depósito de combustible
Choke
Cebador
Filtro de aire
Decompresor
1
3
2
6
5
4
7

Solo 153 Specifications

General

Displacement	51.7 cm³
Power Output	2.0 kW
Cutting Width	230 mm
Weight	8.2 kg
Fuel Tank Capacity	1.0 L
Engine Type	2-stroke
Shaft Type	Straight

Summary

Instruction Manual Introduction

Important Safety Information

Read manual carefully before first operation and strictly observe safety regulations.

Carburetor Adjustment

Carburetor Adjustment Procedure

Steps for setting idle run, maximum RPM, and re-checking idle speed using a tachometer.

Carburetor Adjustment Warnings

Warning regarding setting carburetor for maximum performance and needing a tachometer.

Air Filter Maintenance

Checking and Cleaning Air Filter

Instructions for daily and weekly cleaning, and replacement of damaged air filters.

Spark Plug Checks

Spark Plug Inspection and Replacement

Warning about checking spark plug every 50 hours and replacing if worn.

Fueling and Mixture

Fuel and Oil Mixture Recommendations

Recommended gasoline/oil ratios for different 2-cycle oils and storage tips.

Initial Starting Instructions

Guidance for the first 5 tank fillings, advising against excessive speed without load.

Engine Starting and Shutting Off

Cold Start Procedure

Step-by-step guide for starting a cold engine, including choke and primer usage.

Warm Engine Start Procedure

Instructions for starting the engine after a brief shutdown, with choke left open.

Shutting Off Engine

Procedure for stopping the engine using the stop switch, with a caution about the cutter.

Carburetor Setting Data for Service Personnel

Initial Carburetor Settings

Recommended initial settings for L and H screws and idle speed.

Maximum RPM Warning

Caution against setting maximum RPM higher than recommended to prevent engine damage.

Technical Specifications

Engine and Performance Data

Details on engine capacity, max RPM, fuel tank, carburetor, and air filter type.

Noise and Vibration Levels

Guaranteed and measured sound power levels and weighted acceleration values.

Declaration of Conformity

Product Compliance Statement

SOLO Kleinmotoren GmbH declares sole responsibility for product compliance with EG guidelines.