ENGLISH 1
Original instructions
Read this instruction manual carefully before first
operation and strictly observe the safety
regulations!
Changes to the scope of supply in form, technology
and equipment are reserved. No claims can be
derived from any information and figures in these
original instructions.
The original packaging and, at the end of its
service life, the sprayer must be properly disposed
of according to the local environmental regulations.
The machine can be subject to national rulings for
regular review by designated offices,
as specified
in directive 2009/128/EC.
Information about material ingredients
(VO (EC) No.1907/2006 „REACh“)
can be found on our homepage under:
https://shop.solo.global/Service/Support/Support/
1 EC declaration of conformity
SOLO Kleinmotoren GmbH, Industriestraße 9,
D-71069 Sindelfingen, GERMANY
declares that the following machine, in the
delivered version, corresponds to the provisions
implementing the following directive:
2006/42/EG, 2009/127/EG, 2014/30/EU,
2011/65/EU.
Product designation: Battery sprayer,
Trade designation: SOLO 206 Eazy,
Serial/type designation 20601, 20602
Storage location for the technical documents and
documentation officer:
SOLO Kleinmotoren GmbH, Industriestraße 9,
D-71069 Sindelfingen, GERMANY
01 01 2022
Andreas Emmerich (managing director and
documentation officer)
2 Scope of delivery
Basic unit with hand valve and pressure hose
Spray tube
Pre-installed nozzle assembly incl. nozzle
Assembly parts cap but, O-ring
Carrying belt
Rechargeable battery
Charger
3 Wear parts
The following wear parts are not subject to the
manufacturer's guarantee:
* All rubber parts that come into contact with
spraying liquid, * nozzles, * filters, * seals,
* rechargeable battery
4 Warranty
Please observe that specific warranty conditions
are valid in some countries. In doubt, ask your
vendor.
No guarantee can be granted for any damage
caused by:
Non-observation of the original instructions.
Omission of necessary maintenance and
cleaning work.
Wear and tear from regular use
Use of unapproved working tools.
Use of force, improper treatment, abuse or
accident.
Manipulations by non-qualified persons or from
improper repair attempts.
Unauthorized modifications to the device.
Use of unsuitable spare parts or non-genuine
spare parts.
Use of unapproved chemicals or dilutions.
Damage caused by use in the rental business.
Any warranty work must be performed by one of
our authorised specialist vendors. Cleaning, care
and standard adjustments are not accepted as
warranty services.
For Australia only: Supplementary warranty notes
specifically for Australia
To make a claim, contact Clayton Engineering, 26
French Ave, Brendale, Q, 4500 on phone 1300 798
022 or email sales@claytonengineering.com.au.
You will be asked to provide proof of purchase and
then will be instructed on the procedure for
repairing or replacement of the product under
warranty. All costs incurred for repair or replace,
and additional claims can be discussed at this
stage.
This warranty is provided in addition to other rights
and remedies you have under law: Our goods
come with guarantees that cannot be excluded
under the Australian Consumer Law. You are
entitled to a replacement or refund for a major
failure and for compensation for any other
reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
To Next Page
Loading...
