EasyManua.ls Logo

Solo 206 Eazy - Pre-Use Checks and Filling; Initial Test Run Procedure; Preparing Spray Liquid and Filling Tank

Solo 206 Eazy
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH 7
Before replacing the battery, make sure that the
battery and unit contacts are clean, dry, and free of
foreign bodies.
Put the battery into the device in the correct
position (according to the figure) from above until it
latches noticeably. Check that the battery is seated
securely.
7.4 Test run
Before its initial use, the sprayer should be tested
according to chapter 10.2.
8 Preparing the spray liquid and filling the
spray tank
Prepare the spray liquid according to the
instructions of the chemical manufacturer.
Always prepare the spray liquid outdoors, never in
living quarters, stables or storage rooms for food
and animal feed.
To fill the spray tank, always remove the
rechargeable battery from the unit and close the
protective cover for the rechargeable battery
compartment.
When filling the spray tank, always use the filler
basket with the integrated filter screen (r).
Fill the tank no further than to the upper-most mark
(MAX) of the spray tank.
Overfilling the tank or spills can contaminate public
waterways, rain- and storm water channel and
must be avoided.
Wipe off spilled spray liquid without delay.
9 Use of the device
Do not use the sprayer in wind or rain.
Check the direction of the air movement before
starting work and spray with the air movement,
not against it.
Do not spray towards persons, animals, open
doors and windows, cars or other objects that
may be hurt or damaged by the spray.
Ensure that only the actual spray target will be
wetted. Always aim to obtain even and
homogenous distribution of the spray on the
treated surfaces.
Fig. 8
Fig. 9

Related product manuals