EasyManua.ls Logo

Solo 425-101 - Sprayer Features and Spraying; Nozzle Options and Applications; Spray Tip Assembly Guide; Spraying Procedure

Solo 425-101
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
OPERATING FEATURES:
Nozzles - Your Solo sprayer can provide a variety of spray patterns with the standard and optional nozzle arrangements.
Item Application Part #
Flat spray nozzle Row treatment 4074263
Jet stream nozzle Spot & longer range 4074755
Jet stream nozzle and Shrubs and bushes 4074755
Swirl plate = hollow cone 4074756
Plastic adjustable Spot, shrubs & bushes 4900527
nozzle
Speed Tip Nozzle Row, spot, shrubs & bushes 4074666
*Brass adjustable nozzle and Speed Tip nozzle are not standard items on all Solo sprayers but each may be
purchased as an accessory. Spray tips should be assembled as above for desired spray pattern.
WARNING: Handling the brass parts of this product will expose you to lead, a chemical known by the State of
California to cause birth defects and other reproductive harm and/or cancer. Wash hands after handling.
SPRAYING:
Prime the pump with rapid pump strokes. When you feel very firm resistance, the pressure chamber is filling with
liquid. With repeated piston strokes, the air in the pressure chamber is slowly compressed. In a safe area, point
the wand upward and press the shut-off valve lever spraying for 10 seconds or until no air and only liquid is com-
ing out. This will bleed all of the air out of the hose and wand. By pressing the hand lever, the valve opens, and liquid is
forced through the nozzle. The shut-off valve has a retaining clip which keeps the valve in the “OPEN” position for
continuous operation. Pump using the end of the pump handle, as it is less fatiguing. The volume of liquid delivered varies
with the working pressure which should be as high as needed to ensure an adequate spray pattern for each individual
application.
NOTE: Should the pressure drop very quickly, drain the tank completely and pump without liquid. By this procedure, the air
chamber is refilled with the required volume of air. It is advisable to pump the tank completely empty from time to time.
SPRAY TIP ASSEMBLY
1. Flat spray nozzle
2. Filter
3. Jet cap
4. Swirl plate
5. Nozzle cap
6. Nozzle body
7. Brass adj. nozzle*
8. Nozzle retaining nut
9. Elbow
NEW Solo Speed Tip Nozzle*
(attaches directly to the wand)
5
8
8
8
8
8
7*
3
1
3
6
4
2
2
2
2
2
9
9
9
9
9
Flat spray
nozzle
Hollow
cone spray
nozzle
Brass
adjustable
nozzle*
Jet stream
nozzle
Plastic
adjustable
nozzle

Related product manuals