Nozzles
Flat spray nozzle - surface area & row treatment
Jet cap
Swirl plate
Filter - standard
Sprayer elbow and nozzle assortment
No-drift wide angle flat nozzles - .60 GPM
mainly for spraying herbicides at low pressure. .30 GPM
At 15 psi they deliver: .24 GPM
.12 GPM
Elbow nozzle assembly
Double spray nozzle - for double row application
spraying in two directions simultaneously.
Brass adjustable spray nozzle kit - with jet filter and screw
cap for tree spraying (from fine misting to a jet stream).
Brass adjustable spray nozzle (same nozzle as kit above)
Plastic adjustable nozzle
Hollow cone nozzles - for shrubs & bushes: 1.4 mm
1.8 mm
Foam spray nozzle - for low drift & water saving
application of herbicides which tend to foam.
No drip check valve - prevents spray tip from leaking
when not in use.
Speed Tip Nozzle - Change from a fine mist, or a jet stream or a
flat spray pattern with the twist of a dial.
Nozzle assortment - includes flat, hollow cone, no drift,
and plastic adjustable nozzles.
Extension tubes and spray wands
20” spray wand
20” extension tube
21” stainless steel wand
20” brass spray wand
40” brass telescoping wand
48” carbon fiber wand
60” brass spray wand
4’ to 8’ Carbon Fiber Wand
Note: extension tubes attach to wands to extend length.
Spray wands attach to shut-off valve only.
Spray booms
Spray booms - spray 2 or 4 rows at once with:
2-nozzle spray boom - handheld (total width 33”)
distance between nozzles 24”. Includes 2 flat spray nozzles.
4-nozzle spray boom - mounts on rear of sprayer
(total width 49 3/4”; distance between nozzles 16”).
Includes 4 hollow cone nozzles.
Specialty items
Shoulder Saver Harness - padded shoulder straps and
padded lumbar support reduces lower back fatigue.
Fits all models.
Pressure gauge kits - indicates spray pressure.
Use with shut-off valve 4800170. Fits all models.
Drift guard - complete control for herbicide applications in
berry, flower, vegetable, cotton & other applications.
To Next Page
Loading...
