OPERATOR’S MANUAL & PARTS LIST 425, 475, 425D, 425LC
WARRANTY
Solo backpack sprayers are covered by Solo’s WARRANTY
(5 years for models 425 & 475, 2 years for Model 425D, 425
LC). Solo manufactured parts which fail due to defective
material or workmanship will be repaired or replaced
without charge. Refer to Warranty sections for consumer
and commercial use, of this Owners Manual, for full details.
MAINTENANCE TIP
Cap gasket is pre-lubricated for improved
sealing. Occasional lubrication is recommended.
SAFETY PRECAUTIONS
1. Before using sprayer with chemicals, fill sprayer with fresh
water to assure that you have it properly assembled;
pressurize and practice spraying.
Also, check for any leaks at this time. When thoroughly
familiar with the sprayer operation, follow normal
operating procedures.
2. Ensure all pressure in the sprayer is relieved by locking
the shut-off valve in the open position.
3. Avoid contact with chemicals.
4. Always wear rubber gloves, safety goggles and
appropriate protective clothing.
5. Work in a well ventilated area.
6. Individuals should be trained in the proper use of this
sprayer, chemical handling procedures, and first aid/
emergency care. Where training is not available,
individuals should study and follow the procedures
detailed in this manual.
If you are missing parts, instructions or have questions, DO NOT take this unit back to the store.
Call 1300 798 022. Solo will send the missing parts/information to you promptly.
STOP
Visit us on the web at www.soloaustralia.com.au Troubleshooting and parts ordering available on-line.
CUSTOMER SERVICE COMMITMENT FROM SOLO’S SERVICE DEPARTMENT: In the event the sprayer you have purchased has missing or damaged parts,
please call 1300 798 022, 9:00am – 5:00pm Mon-Fri. In order to assist your service representative, please have the following information available: sprayer model number,
part description and part number. A parts list is included in your operator’s manual. Solo is committed to your satisfaction and is continuing its efforts to earn your future business.
Chemicals can be harmful to individuals and the environment
if improperly used. In addition, some chemicals are caustic,
corrosive or poisonous and should be avoided. Read
warnings and chemical manufacturers’ instructions. Solo
high density polyethylene sprayers are fitted with Viton
®
seals which are resistant to a wide variety of agricultural and
household chemicals; however, care should be exercised
to ensure that sprayer components are clean, functioning
properly, and in a good state of repair before and during use.
If in doubt about a particular chemical, check with the
manufacturer. If you suspect or observe indications that
the material may be unsafe in a Solo sprayer...STOP.
DO NOT USE OR APPLY CHEMICAL. ALWAYS WEAR
RUBBER GLOVES, GOGGLES, AND APPROPRIATE
PROTECTIVE CLOTHING!
Read and follow operating instructions:
• Donotllwith,use,orsprayammablematerials.
• Donotmodifysprayer.
• Neversprayinthedirectionofhumans,animals
or property which might be injured or damaged
by spray formula.
• Donotusedisinfectants,solventsorimpregnatingagents
unless first tested to ensure they are not harmful to the
environment or sprayer.
• Donotuseliquidswithatemperatureabove43°C.
• Wearappropriateprotectiveclothingtopreventcontact
with chemical agents.
• Rinseandcleansprayerthoroughlyafterusing.
Disposal of contaminated rinse should be in accordance
with applicable ordinances. Observe the precautionary
instructions of the chemical manufacturer.
• DO NOT USE ANY ACID (INCLUDING CITRUS), PETRO
CHEMICALS OR CAUSTIC CHEMICALS (including
bleach).
• Rememberthatasprayerwithliquidisasignicantamount
of weight (15kg per 15 litres). Use caution when bending,
leaning or walking. Bend at the knees rather than the waist.
• Duringsprayeroperation,thepressurecylinder(4400240)
containscompressedairandliquid.Compressedairand
liquidunderpressureareinherentlydangerous.Before
making adjustments on sprayers fitted with a pressure
regulating valve body (40 74 323) or control knob
(40 74 344) located on the pressure cylinder or any
other repair or inspection of any sprayer, be sure to
relieve pressure through the shut-off valve and wand.
PISTON DIAPHRAGM
To Next Page
Need help?
General
