17
1
2
4
3
18
7
6
11
24
5
12
18
14
15
25
17
16
13
9
19
18
8
10
22
20
21
23
Important Note!
1. The oil and fuel tank lids are sealed with a O-ring.
Both tank lids should be fingertight only. Avoid the use of tools for tightening.
2. A cardboard washer is placed by the factory under the bar side cover for protection
during transport. That washer should be removed and discarded when fitting
the guide bar for the initial use of the saw
1.
2
.
➟
1 Saw chain
2 Guide bar
3 Handle bar
4 Hand guard
5 Rear handle
6 Choke lever
7 Half-throttle check pin
8 Oil tank
9 Starter handle
10 Fuel mixture tank
11 Ignition switch
12 Throttle lever
13 Primer
14 Spark plug
15 Air filter
16 Idling set screw (T)
17 Carburetor adjustment screws (H/L)
18 Anti-vibration mount
19 Cooling air induction area
20 Muffler
21 Clutch
22 Brake band
23 Chain brake
24 Throttle lock
25 Air inlet
To Next Page
Loading...
