3
SOLUXTEC USER GUIDE 2023_Version 2/a_ALL RIGHTS RESERVED
1 INTRODUCTION
Thank you for electing SOLUXTEC GmbH PV modules. The following user guide is covering
important points to be read and understood before installation of SOLUXTEC products. This
document is not having any aims in relation to quality warranties but only for safety, electrical,
mechanical and general handling of SOLUXTEC products.
In case a pv installation is not respecting above mentioned points, the quality warranty of
SOLXTEC product will become invalid.
This document belongs to SOLUXTEC, all contents are SOLUXTEC intellectual properties.
SOLUXTEC reserves the right to modify this document without prior notice.
- Please read this document carefully before installation
- Please make sure that this document is always available for installers and operators to
handle SOLUXTEC’s products.
- Please give a copy of this document to the installation owner.
- If any questions are not well answered in this document, please contact SOLUXTEC
support prior installation.
2 SAFETY
The installation of photovoltaic modules must respect the current standards from the
place of installation. It is imperative to refer to the standards of each local authority
in case specifics rules are imposed.
Installation of photovoltaic modules must be operated by qualified peoples, knowing
and respecting all regulation and requirements for compliance with country of
installation.
Solar modules create DC electricity and are even energized under a slight
illumination level. Several modules connected together may occur an accumulation
of voltage and intensity. Please respect all personal security to avoid a risk of
electrocution.
Please respect the data given from the elected module’s data sheet to respect all
module’s limits and comply with other materials that will be need to operate the
photovoltaic generator.
- Never open the junction box on the back of the photovoltaic module
- Make sure that connectors are clean and not dirty or wet before connection.
- Never disconnect the photovoltaic connector under load. Always turn off the DC breaker
prior any photovoltaics connector disconnection.
- Tools must be dedicated for solar installation and supporting DC current.
- The final photovoltaic generator must follow all needed standard and requirement in
compliance with the installation country (PV, inverter, cable, grounding and other
accessories from the pv generator).
- Never disassembled any part of the module.
To Next Page
Loading...