SOLUXTEC Das modul Mono XSC - Regulation; Transport and Handling

4
SOLUXTEC USER GUIDE 2023_Version 2/a_ALL RIGHTS RESERVED
3 REGULATION
All modules presented in this document are covered from the following standards:
 IEC 61215
 IEC 61730
 IEC 62804 (PID)
 IEC 61701 (SALT MIST)
 IEC 62716 (AMMONIA)
 EMC and Low Voltage regulation
NOTE: As SOLUXTEC is always improving his products. Please contact your customer service
if a standard is missing for your project from above list.
4 TRANSPORT AND HANDLING
During transportation and Interim storage, following point have to be respected:
Transportation of the modules need to be done only with SOLUXTEC original
packaging.
Never exceed the maximum number of pallets to be stacked. Only original SOLUXTEC
packaging may allow pallet stacking.
When unpacking modules from the packaging, please wear soft and clean gloves. It is
forbidden to use suction cup to carry the module as it will damage the anti-reflective
coating for the solar glass.
It is forbidden to carry/lift the modules from the solar cables or from the junction box or
any conductive elements.
Do not drop module directly on module.
By handling modules be cautious especially on the corners to not shock them.
By handling the modules, never scratch the anodised coating of the frame.
Corrosion may occur and brings to a mechanical resistance diminution.
It is forbidden to drill holes in the aluminium frames.
It is forbidden to paint the modules or to apply any adhesive on the module’s surface.
Never walk on the module.