Solvit CareLift User Manual (English)

To Next Page

140515

CareLift

™

Lifting Harness

Care & Use Guide

Thank

you for purchasing the Solvit CareLift Lifting Harness. This Guide covers both Rear-Only and Full-Body

versions of the Harness. The Rear-Only version contains a rear lifting panel with rubberized handle, an integrated

“belly band” which supports the dog’s abdomen, two leg straps and a lifting leash. The Full-Body version includes

the above pieces, plus a

front lifting panel with

rubberized handle and

chest lifting section, plus

an adjustable shoulder

strap (see Fig 1 for

identification of parts).

To place Rear section on dog

: Un-fasten the plastic buckle connector on one side of the belly band and on each leg

loop. Place the lifting panel on the back of the dog a few inches in front of the base of the tail. Wrap the belly band

around the abdomen and connect on opposite side, then run each leg strap under a leg and connect to the rear of the

lifting panel. Adjust straps and check for fit – the harness should be snug but not too tight. For improved fit, the leg

loops have a swiveling connector on the front end of the loop. This connector can be placed in different positions on

the Rear Lifting Panel (two positions on Medium, three positions on Large). To re-position the connector, refer to the

images below and follow these instructions: 1) slide the yoke piece forward to disengage from the “peg” on the pivot

piece; 2) unfold pivot piece so it can be slid out of place on the strap, then re-insert into another position on the strap;

3) fold the pivot piece back into position and slide the yoke piece over the peg on the pivot piece to finish.

Need help?

Do you have a question about the Solvit CareLift and is the answer not in the manual?

Solvit CareLift Specifications

General

Adjustable Straps	Yes
Intended Use	Assisting pets with mobility issues
Material	Nylon
Sizes Available	Small, Medium, Large
Dimensions	Varies by size
Features	Padded handle, adjustable straps