EasyManua.ls Logo

Solvit Pet Safety Seat User Manual

Solvit Pet Safety Seat
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
140609
Pet Safety Seat
Care & Use Guide
Thank you for purchasing the Solvit Pet Safety Seat. Check to make sure the contents include a fabric cover with
tether in polybag; a three-panel plastic main Seat section; and the following plastic sections: Front Strut; Rear Strut;
Right Wall; and Left Wall (name embossed on the side of each).
Assembly: (Make sure the smooth side of each plastic panel faces “in” and the side with round depressions faces
“out”). Insert tab A on Front Strut into slot A in Left Wall and slide Front Strut in the direction of the arrow until tab
A is in the fully locked position.
Repeat this procedure to lo
ck tab B on Front Strut into slot B on Right Wall, and to lock tabs C and D on Rear Strut
into slots C and D on the Left and Right Wall sections.
The main Seat section is a three-panel piece that was
folded in a “Z” shape in the package. Before
connecting to the Left and Right Wall sections, fold
the Seat section into a “U” shape with the smooth
sides facing “in”. Insert double-tab E on the front
panel of the Seat section into slot E on the Left Wall
and slide to lock. Repeat for tab G then repeat for
tabs F and H into the corresponding slots on the
Right Wall.
Place the as
sembled plastic frame upside-down on a clean surface. The
Outer Fabric Shell has a zipper and small tags marked Z (next to zipper)
and X (on opposite seam). With zipper in the fully open position, slide the
fabric shell over the plastic frame so the Z seam aligns with the H corner at
the back of the plastic frame and the X seam aligns with the G corner.
Question and Answer IconNeed help?

Do you have a question about the Solvit Pet Safety Seat and is the answer not in the manual?

Solvit Pet Safety Seat Specifications

General IconGeneral
BrandSolvit
ModelPet Safety Seat
CategoryPet Care Product
LanguageEnglish

Summary

Pet Safety Seat Assembly

Assemble Plastic Frame Components

Connect Front and Rear Struts to Left and Right Walls by inserting tabs into slots.

Attach Main Seat Section

Fold the three-panel seat section into a "U" shape and attach to the assembled frame.

Install Outer Fabric Shell

Slide the fabric shell onto the plastic frame, aligning seams and closing the zipper.

Vehicle Installation and Safety

Install Top Fabric Liner

Insert the top liner into the seat, aligning seams and fastening hook-and-loop strips.

Secure Seat in Vehicle

Thread seat belt through frame and tether loop, then buckle and tighten.

Travel Safety Recommendations

Use a harness with the safety tether for maximum travel safety.

Care and Warranty Information

Cleaning Instructions

Fabric pieces can be machine washed in cold water; machine dry without heat or line dry.

Limited Lifetime Warranty

Product is warranted against defects in materials or workmanship for its lifetime.

Related product manuals