User Manual
Setup the HomePlug AVs
For Twin Pack
HomePlug AVs from a Twin Pack are preconfigured to have a common Private Network Name unique
for that pair. All you need to do is connect the HomePlug AVs to an Ethernet device and then plug
it to a wall socket.
To setup a pair of HomePlug AVs:
1. Plug one end of the Ethernet cable to your Ethernet device and then connect the other end
to HomePlug AV.
2. Connect the HomePlug AV to a wall socket.
3. Plug one end of the Ethernet cable to your other Ethernet device and then connect the
other end to HomePlug AV.
4. Connect the HomePlug AV to a wall socket.
For Single Pack
A HomePlug AV from a single pack uses a random Private Network Name that prevents it from
communicating with other HomePlug AVs. To add it into an existing network, you need to use either
the Simple Connect button or the HomePlug AV Utility software to change the random Private
Network Name to the Private Network Name being used by the existing HomePlug AV network.
To add a HomePlug AV to an existing network:
1. Plug one end of the Ethernet cable to your Ethernet device and then connect the other end
to HomePlug AV.
2. Connect the HomePlug AV to a wall socket.
3. Add the new HomePlug AV by using either Simple Connect or the HomePlug AV Utility
software. To use Simple Connect, please refer to Joining an Existing HomePlug AV Network.
To use HomePlug AV Utility, please refer to Private Network Name.
Page 29 of 43
To Next Page
Loading...