To Next PageTo Next PageWhat to do if my SOMFY Remote Control window covering stops during activation?
If your SOMFY Remote Control window covering stops mid-operation, it might be due to an obstruction. Check for any obstacles and remove them before trying again. It's also possible another control device is sending a conflicting command. Wait for the current activation to finish before reattempting.
Why is my SOMFY Telis 1 Chronis RTS Remote Control not working?
If your SOMFY Remote Control isn't responding, first, replace the batteries. If that doesn't work, the remote might not be programmed correctly; see the section on adding/deleting a Telis 1 Chronis RTS. Also, nearby radio equipment could be interfering, so try turning those off. Lastly, the motor(s) or receiver(s) might be in thermal shut-off mode; wait for them to cool down before trying again.
Why is my SOMFY Telis 1 Chronis RTS sending commands at the wrong time?
If your SOMFY Remote Control is sending commands at the wrong time, the "Simulated presence" function is likely activated. Deactivate this function to resolve the issue.
What to do if SOMFY Telis 1 Chronis RTS Remote Control window coverings don't respond to automatic commands?
If one or more SOMFY Remote Control window coverings consistently fail to respond to a programmed automatic command, it's possible that interference from another automatic device in your home is the cause. Try changing the programmed time of the automatic command to avoid this interference.
General| Type | Remote Control |
|---|---|
| Technology | RTS (Radio Technology Somfy) |
| Frequency | 433.42 MHz |
| Battery Life | Approximately 3 years |
| Number of Channels | 1 |
| Color | White |
| Compatibility | Compatible with all RTS motors and receivers |
| Programming | Easy programming via the remote control |
Details the physical components and buttons of the Telis 1 Chronis RTS remote control.
Explains the indicators and information displayed on the remote control's LCD screen.
Initial configuration process for the remote control after battery installation.
Configures automatic commands for daily, workday, and weekend schedules.
Sets a single automatic command for window covering operation.
Procedure for associating or removing window coverings from the remote control.
Removes previously programmed automatic commands from the remote control.
Adjusts fundamental parameters of the remote control, like year and country.
Used for occasional orders and deactivating automatic programming.
Controls window coverings based on programmed settings for times or days.
Randomly varies programmed operation times to simulate occupancy.
