SOMFY TELIS SOLIRIS - User Manual

Programming Manual
http://www.remotecontrol-express.com - TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151
SOMFY Telis Soliris – Telis 1 – Telis 4
Programming of your new remote control:
If the receiver is separated from the motor:
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button for 2 seconds (prog). The LED
light on the receiver illuminates (L1) (fig 1).
3. With a sharply pointed object, press the hidden button behind your new remote control (fig
2). The LED light L1 blinks.
4. Wait 10 seconds.
5. Your new remote control is programmed.
If the receiver is integrated to the motor:
1. Approach your motor.
2. Press both buttons (those with arrows) on your remote control that has already been
programmed at the same time (fig 1). Let them go.
3. With a sharply pointed object, press the hidden button located behind your new remote
control (fig 2).
4. Wait 10 seconds.
5. Your new remote control is programmed.
To add a remote control

Summary

SOMFY Telis Soliris Telis 1 Telis 4 Programming

Programming New Remote Control

Instructions for programming a new remote control for SOMFY Telis devices.

Programming with Separated Receiver

Steps to program a new remote when the receiver is physically separated from the motor.

Programming with Integrated Receiver

Steps to program a new remote when the receiver is integrated directly into the motor.

Programming New Remote Control Method 2

Using Pre-Programmed Remote

Procedure to program a new remote using an already programmed remote control.

SOMFY TELIS SOLIRIS Specifications

General

Number of Channels	1
Frequency	433.42 MHz
Power	3V
Compatibility	SOMFY roller shutters, awnings, and projection screens
Range	Up to 30 meters