1. Press and hold the Radio button (2) for 20 seconds.
The Radio LED (3) initially shines steadily for 5 seconds, flashes
once intermittently for 10 seconds, and then shines steadily again
for a further 20 seconds before going out. This indicates that the
memory has been wiped.
4.6 Programming the transmitter button to pulse mode
1. Press and hold the Radio button (2) for approx. 0.5 seconds.
The Radio LED (3) lights up, program mode starts.
2. Press any button (1) on the transmitter.
The Radio LED (3) goes out. That button on the transmitter is
programmed as the pulse button. The command sequence is:
Open – Stop – Close – Stop – etc.
If no radio signal is sent within 10 seconds of the start of program
mode, program mode is terminated; the Radio LED (3) goes out.
4.7 Closing the housing cover
On completion of initial operation, close the housing cover and install
the lamp cover.
To Next Page
Loading...