6.2 DIP switches
Only switch the DIP switches when the control unit has been
disconnected from the main power supply.
All DIP switches are set to “OFF” by factory default.
The DIP switch setting is read in by the control unit:
• after the control unit is switched on;
• during the self-test, after the door reaches the end positions;
• in every intermediate position, if the door is not running.
Settings
Mode
Function
DIP 1 OFF Warning light flashes while door is moving.
ON Warning light shows steady light while door is moving.
DIP 2 OFF Light barrier with NC contact connected to safety input 2.
ON 2-wire light barrier connected to safety input 2.
To Next Page
Loading...