7 Radio receiver
Each button on the transmitter has a permanently stored radio code
(factory setting). When you program a button into the radio receiver,
the button’s radio code is transferred to the receiver, where it is
assigned a command.
For security reasons, you should completely wipe the radio receiver’s
memory:
• before programming transmitters for the first time and
• if a transmitter gets lost.
The programmed commands are retained in the event of a power
failure.
7.1 Wiping the radio receiver’s memory
1. Press and hold the Radio button (2) for 20 seconds.
The Radio LED (3) initially shines steadily for 5 seconds, flashes
once intermittently for 10 seconds, and then shines steadily
again for a further 20 seconds before going out. This indicates
that the memory is wiped.
The entire memory of the radio receiver is wiped.
7.2 Programming the transmitter to
Open-Stop-Close
1. Press the Radio button (2) for approx. 0.5 s.
The Radio LED (3) and the Status LED (4) light up. Program
mode begins.
To Next Page
Loading...
