2. Select the function that you want to be performed when this
transmitter key is pressed in future.
3. Briefly press the required button in the housing cover.
The Status LED (4) flashes once intermittently.
4. Press any button (1) on the transmitter.
The Radio LED (3) goes out.
The function is assigned to the button you pressed.
5. Repeat steps 1 to 4 for the other buttons on the transmitter and
other functions.
If no radio signal is sent within 10 seconds of the start of program
mode, program mode is terminated; the Radio LED (3) goes out.
7.3 Programming the transmitter button to pulse mode
1. Press and hold the Radio button (2) for approx. 0.5 s.
The Radio LED (3) and the Status LED (4) light up. Program
mode begins.
2. Press the required button on the transmitter.
The Radio LED (3) goes out.
The button on the transmitter is programmed as the pulse
button.
If no radio signal is sent within 10 seconds of the start of program
mode, program mode is terminated; the Radio LED (3) goes out.
7.4 Wiping individual transmitter buttons
1. Press and hold the Radio button (2) for approx. 5 seconds.
The Radio LED (3) flashes once intermittently.
2. Press the button you want to delete on the transmitter.
The Radio LED (3) goes out.
The button is deleted from the receiver’s memory and no longer
has an assigned function.
RDC vision
en36
To Next Page
Loading...
