SOMMER RDC vision - Page 37

7.5 Wiping all transmitter buttons
1. Press and hold the Radio button (2) for approx. 10 seconds.
 The Radio LED (3) goes out.
2. Press any button on the transmitter.
 The Radio LED (3) goes out
 All buttons are deleted from the receiver’s memory and no
longer have an assigned function.
7.6 Setting partial opening
In certain cases, you might want to open the closed door only part of
the way, e.g. to put away a bicycle. The “Partial opening” function can
be set for this purpose.
1. Close door.
2. Set DIP switch 6 to “ON”.
3. Press and hold the Radio button (2) for approx. 0.5 s.
 The Radio LED (3) goes out.
4. Select the “Open” function.
 The Status LED (4) flashes once intermittently.
5. Select the “Open” function again.
 The Status LED (4) lights up.
6. Press the required button on the transmitter.
 The Radio LED (3) goes out.
7. Using the same button on the transmitter, open the door as far as
you want it to go, stop it and close it.
 The pressed button is programmed for the “Partial opening”
function.
RDC vision
en 37