9 Maintenance and care
Only a qualified electrician (in compliance with BGV A3,
§ 2 Subsection 3; only applies in Germany) may work on the
control unit.
Risk of electric shock
Do not touch live parts (ends of cables, contacts, etc.) while the
control unit is still connected to the power supply.
The control unit housing must never be sprayed with a water hose or
high-pressure washer.
Do not use acids or alkalis for cleaning.
Regularly check power cables for insulation defects or cracks.
Replace faulty or defective cables immediately, directly after
switching off the power supply.
Check the control unit housing regularly for insect infestation and
moisture; if necessary clean or dry.
Check that the lid of the control unit housing fits correctly and, if not,
rectify.
9.1 Regular testing
Regular checks should be carried out to ensure that all safety equip-
ment is fully functional. These checks should be documented and
carried out at maximum 6-month intervals (see EN 12453:2000).
Check that pressure-sensitive safety devices (e.g., safety contact
strip) are working properly every 4 weeks; see EN 60335-2-95.
9.2 Warranty and customer service
The warranty complies with statutory requirements. Please contact
your specialist retailer/supplier if you have any queries regarding war-
ranty. The warranty is only valid in the country in which the product
was purchased.
Batteries, fuses and bulbs are excluded from the warranty.
Ownership of replaced parts passes to us.
RDC vision
en40
To Next Page
Loading...
